Profile: 1stSource Products, Inc. supplies hardware systems & components to OEMs, distributors, and end users worldwide. We offer overhead conveyors, ball transfers, light duty conveyors, bearings, industrial hinges, handrail fittings, fence hardware, and mail posts. We provide prototype development and supply proprietary components to many OEMs. Our development programs are innovative, resulting in the reduction of both tooling and per-unit cost for long term supply. Our solid machined wheel chain is a 6” pitch chain with an 80lbs load rating. The vertical wheel has a load pin that supports the load. This chain is provided in 10’ lengths and is boxed. It is provided with machined vertical and horizontal wheels. The manual brush oilier applies lubricant to the chain via gravity feed and the chain engages the brush. This oilier is not provided with a section of track. A slot must be cut in the tip of the track to accommodate the brush. Our automatic lubricator with a timer is provided with a two gallon self-contained reservoir, low level float switch, and a low level pilot light. The lubricant is shot though five adjustable nozzles to the bearings and knuckle pivot points. This unit requires 120 VAC and compressed air. The unit is mounted on a 24” section of track and is ready to install. Our prototyping capabilities include but are not limited to steel stampings, machined steel components, steel forgings, injected molded plastic components, precision chains, die cast aluminum components, sprockets, fabricated machined, and welded assemblies.