Profile: American Environmental Fabrication and Supply, LLC designs, builds & supplies industrial equipment and products. Our products are designed to meet the rigorous industrial challenge without equipment or product failure. We have several regenerative thermal oxidizers to choose from, including a new VAM methane regenerative thermal oxidizer. Systems may be designed for either induced or forced draft, depending on the requirements. Regenerative thermal oxidizers are equipped with a automatic dual hot air by-pass system for extreme overloading of VOC's and RTO equipment protection. If one of the hot air by pass system fails for any reason the other by-pass system will open and function properly to handle the added operating temperature. All regenerative thermal oxidizer systems are designed to work in extremely harsh environmental conditions. The RTO exhaust stack, skid, grating and all duct & dampers are hot galvanized dipped adding years to the equipment life. The RTO equipment is industrial lagged and trimmed for aesthetics (color of choice) and safety, requiring no painting or thermal insulation of the chambers. The regenerative thermal oxidizer stack base is engineered to extend up to 120ft on all standard RTO units. The RTO duct work is made with ¼" metal with the heat recovery chamber and the regenerative thermal oxidizer combustion chamber made of ⅜" plate, assuring long lasting life & protection against equipment skin distortion. Monolith ceramic media blocks are used in many industries as a continual heating source. When these are used in furnaces, regenerative thermal oxidizers (RTO), catalytic thermal oxidizer (CTO) and many other types of furnaces & heating systems can retain a high level of BTU value during the systems process with the use of ceramic blocks that can lower fuel consumption as much as 90%.