Electrode Blanks are used to create a blank for an electrode. The geometry to create the electrode tip using the electrode feature command. Then use this command to complete the construction by removing all electrode geometry entirely from original part and replace it with an instance of a component. The new electrode part can then be brought into a drawing sheet and an electrode table created. A blank is a rectangular or cylindrical top for the electrode tip. Rectangular blanks may have a mark to assist with correct orientation. A mark is either a chamfer in one of the four corners or half cylinder notch removed from the middle of the front or back. Choose to have the blank centered at the datum origin or at the center of the oriented bounding stock box, which is the default.