Profile: Enviromesh specializes in providing woven and welded mesh gabion systems. The gabion mesh fabric is formed by weaving adjacent strands of wire by twisting them through one and a half turns at intervals, forming a hexagonal shaped mesh. The ends of the mesh wires are wrapped around a heavier transverse edge wire to form the panels. The tensile strength of the mesh in the direction of the weave is greater than across the weave. The gabion box is manufactured from a main panel that forms the face, base, rear and lid of the unit. The side panels and diaphragms are then jointed to the base section of the main panel. The unit is then folded flat for transportation. Gabion cladding units are a welded wire mesh box system that is configured in a different way such that the unit is sub-divided into cells both horizontally and vertically, allowing each course of cells to be filled. Normally the course lift is 686mm high but for overall heights that are not a multiple of 686mm, the cell height at the base can be manufactured up to 1m in height or the top cell reduced in height providing it is not less than 152mm.