Magnetic V-block Standard
Description: Standard Magnetic V-Block is used for quality control, tool room, and standard room. It has high magnetic pull, which make it suitable to be used for drilling and grinding and even for light milling work. The V block has a total three magnetic surfaces. The top and the bottom with 90 V angle and end surface opposite to switch. All the three magnetic surfaces and the two sides are carefully ground. Their accuracy for flatness, parallelism, and squareness is within 0.005 mm for 2″, 3″, 4″, 6″ `V' blocks and 0.010 mm for 8″ `V' blocks. When turned `ON' all three magnetic surfaces are activated simultaneously. The permanent magnetic holds the work firmly in the `V' and if the block rests on a magnetically conductive surface, it is held firmly to this surface. The magnetic pull is constant and will not decrease even after long use. The magnetic system being shielded from penetration of moisture cannot be damaged by coolants or other fluids.
Other Catalogs (From Hotel Krishna International (India) Ltd.) :
