Lighting Control Panels are known as switching or dimming panels, controllers, sequencers and automation panels. Lighting control panels are used to control lighting throughout buildings or other structures. Its feature includes interior & exterior lighting control, system clock, which provides time scheduled or astronomic control, DIN rail accommodates up to 12 contactors and code compliant lighting shutoff control.

Control systems training is provided for improving control performance and reducing variability. The major topics of this training include development of tuning strategies to improve stability in the key process variables, troubleshooting techniques to identify and correct controller induced variability problems, techniques to assist in the identification/elimination of process and product variability and time series analysis techniques such as the power spectrum.

Coolant Manifold comprises of 'T' fittings, intra-cylinder transfer tubes and AN fittings. It is designed to accommodate inter-cylinder movement that results from both thermal expansion and engine case flex without leakage occurring and also without incurring any repetitive stresses in the components that could result in fatigue failure.

Crane crash avoidance sensor is used as an early warning sensor for preventing collision of overhead cranes running of the same rails. These are installed face-to-face on adjacent overhead cranes running on the same rails. When one crane approaches the detection area of an adjacent crane, its sensor detects the microwaves transmitted by the sensor mounted on the opposite crane and an alarm is generated, thus preventing collision.

Crankcase Pressure Regulators for an internal combustion engine. It has floating-disk type vacuum pressure regulator operatively connected to a breather tube. This is for blow by gases upstream of a flow restriction such as an oil separator. This valve automatically throttles the high pressure suction vapor form the evaporator until the compresser handle the load. It should be installed in the suction line close to the compressor suction valves. It can be used for, the problem of low temperature compressor tripping.