Autoclave RTDs eliminate all of the problems associated with standard probes where the pressure and vacuum cycling of autoclaves forces moisture inside the probe, resulting in incorrect, low temperature readings and reduced life. These are specifically designed for the pharmaceutical, biotechnology and medical applications.

Automatic burettes are used for series of tests. It is connected with a bottle, which contains the titration solution. The air is pumped into the bottle by a small rubber air pump, created the pressure in the bottle which the rises the solution to the top of burette. When the burette is full, the valve is released; the pressure in the bottle falls and the burette automatically sets itself to zero. Work with automatic burettes is by far faster and the consumption of standard solution is smaller. Automatic titrators are known as differential titrators. These instruments add titrant at a constant rate and electronically take the derivative of the potential versus time curve that is produced.

The automatic digital polarimeter measures optical rotation of optically active samples across a wide range of laboratory application. It is easy to operate, with automated detection and digital angle conversion. It will also measure samples with low transmittance. It is designed for use in many applications that require measurement of optical rotation.

Automatic Level Controllers is a device that keeps the effluent at the proper depth. It is positioned in the effluent channel downstream from uv modules. It consists of a baffle balanced by weights. They can be opened completely and rested on a stop chain to lower the depth in the channel to a minimum level. It is a means of maintaining a signal at such a level that the power amplifier performs near its maximum capability with out being over driven on signal peaks.

Automatic meter reading systems consist of three primary components, such as meter interface module, communications systems and central office systems equipment. Meter interface module with power supply, meter sensors, controlling electronics and a communication interface that allows data to be transmitted from this remote device to a central location. Communications systems are used for the transmission, or telemetry, of data and control send signals between the meter interface units and the central office. Central office systems equipment consists of modems, receivers, data concentrators, controllers, host upload links, and host computer.

Automatic Ozone Chamber is designed to provide precise, accurate ozone and concentration environment for rubber and polymer test. It is widely applied to accelerated ageing research, quality control and assurance tests and R&D laboratory formula experiments for cracking resistance. It has wide ranges of ozone concentration that satisfy user's different requirements. It is controlled and measured accurately by means of precise detecting system. It provides both static and dynamic strain sample holders that conform to international standards. It has excellent system control. It maintains rapid resumption of O3 concentration during continuous circulation with the ability of automatically and steadily keeping the chamber temperature. It provides full automatic test after simple settings. It is designed to determine the resistance of rubbers and polymers to ozone and suitable for accelerated aging research, quality control and assurance tests, and research and development laboratory formula experiments.

Automatic Recirculation Valve utilizes three valve elements to accomplish smooth and no disruptive switching of fluid flow between main fluid flow & recirculation fluid flow. An automatic recirculation valve has an inlet, a main outlet and a recirculation outlet. This automatic recirculation valve is used in recirculation lines of centrifugal pumps.

Automatic sampler is designed to take almost any sample size automatically during a blending or mixing operation. It provides a method to take samples at any point in a process system for verification of dry bulk materials. It is typically constructed of 304 or 316 stainless steel materials. It is designed for mounting directly on a mixer, discharge chute, or any place in the process desired.