A ball bearing is a common type of rolling-element bearing, a kind of bearing. The term ball bearing means a bearing assembly, which uses spherical bearings as the rolling elements. It also means an individual ball for a bearing assembly. Ball bearings typically support both axial and radial loads and can tolerate some misalignment of the inner and outer races. Ball bearings tend to have lower load capacity for their size than other kinds of rolling-element bearings due to the smaller contact area that spherical shapes provide.

Ball bushings operating on hardened steel shafts provide many of the low friction, minimal characteristics of radial rolling bearings. The ball bushings, which provides linear travel along the shaft, limited only by built-in motion stoppers, contains three or more oblong circuits of recirculating balls. One portion of the oblong ball complement supports the load on the rolling balls while the remaining balls operate with clearance in the return track. Ball bushings can be lubricated with medium-heavy weight oils or with a light grease to prevent wear and corrosion for high linear speeds, light oils are recommended. Seals can be provided; however, friction is increased significantly.

Ball piston pump is a very simple pump design. It has a rotor, which revolves around an internal stator. The rotor has twelve cylinders machined out of it, and each cylinder has a ball inside, which can slide in and out of the cylinder. The balls ride along a two-railed track machined into the outer housing. The balls revolve around the pump in a perfect circle. The center point of the circle, which the balls revolve around, is offset from the center point of the stator and the rotor, the balls and the rotor have relative motion to each other. This relative motion increases and decreases the volume of each cylinder, allowing the mechanism to draw in fluid during one half cycles and expel it during the other half cycle.

Barrel Dispenser is a compact & lightweight flow-controlling device designed for dispensing liquids from horizontally stacked barrels. The opening is controlled by spring-loaded spindle, which always keep the valve in closed condition. Barrel dispensers are directly fitted to MS and HDPE plastic barrels.

Barrel Pump is a small pump with an extended suction duct that is designed to pump fluid from barrels. It is commonly used to decant liquid additives during the preparation of treatment fluids at the well site. With each rotation of the barrel, the water inlet scoops in a half-coil of water and a half-coil of air. The section of air trapped inside each coil functions as a spacer. It moves most of the air and it should be cleaned and lubricated.

BC Inline Centrifugal Fans are quiet, efficient, and exhibit non-overloading horsepower characteristics. It offers the combination of superior performance of housed centrifugal fans and the space saving configuration of axial fan types. This allows the space saving advantages of the in-line design, which eliminates transitions, and system turns. It is available in vertical and horizontal configurations as well as carbon steel, stainless steel, special alloys, and special coatings. It is used primarily for low to medium pressure return air, systems in heating, ventilating, and air conditioning applications. It is available in low operating speed and high. It provide the efficiency combine to provide longer, reliable, and quiet operation.

Bearing Packer removes old grease from race & cage of roller, ball type bearing and repacks them with fresh lubricant. It handles all bearings from 3/4″ inside diameter to 6″ outside diameter. It has mounting holes for attachment to bench. It is used with hand gun or power pump.

Bearing Seals are axially loaded by a pressure pad and depending on the size of bearing. Bearing seals have two basic functions such as to keep contaminants out of the bearing and to keep the lubricant in the bearing. Bearing seals keep lubricant in the bearing and prevent dirt from entering the bearing. Bearing seals are made of felt material and used to keep lubricant around the bearing & keep dirt out.