Belt/pulley alignment reduces both pulley and belt wear and machinery vibration, which in turn leads to improved machine performance. A good pulley alignment reduces unscheduled downtime and improves the reliability of the equipment. It is mounted magnetically against inside or outside face of pulley and the targets against the face of the opposite pulley. It is easy to use, and requires only a single operator.

Bi-Phase Rotary Separator Turbine is used for separating gas and liquid. The Bi-Phase unit meets or exceeds the separation efficiency of a conventional vessel separator. It operates reliably over a wide range of flows and transient conditions. The unit is able to handle slug flow and normal sand production without damage or loss of separation quality. The Bi-Phase turbine offers one of the highest throughput-to-size ratios of any separation device. The unit's design allows for turndown in increments of 1/8th down to a minimum of 12.5 percent of the inlet flow without affecting performance. Separation efficiency of the gas and liquid exceeds that of a conventional vessel separator, with approximately 75 percent weight and 65 percent space savings.

Blisks are single-engine component composed of a rotor disc and blades through machining from a solid piece of material or blades to the rotor disc. These are one-pieced parts for compressors in aerospace applications. Its advantages include remove the need to attach the blades to the disk and thus decreases the number of components within the compressor while at the same time decreasing drag and increasing efficiency of air compression within the engine.

Blowers are used in electronics, servers, workstations, and other applications needing a compact and reliable means of cooling.

Boiler feed pumps are an important part of any boiler operation. They control the amount of water fed to the boiler and the manner in which it is fed. They operate in centrifugal-continuous as well as turbine-intermittent mode. They are used in conventional and nuclear power stations. Boilers typically employ a modulating feed water regulator and will continuously feed water to the boiler at various rates depending upon the water level in the boiler. Boiler feed pumps close the boiler, steam and condensate loop by returning the condensate back into the system for reuse.

Boiler feed pump controls the amount of water supplied to the boiler and the manner in which it is fed. This is used for conventional and nuclear power stations. It delivers feed water to the steam-generating power plants. This consists of a cast bronze body, brass end cap and packing nut with stainless steel piston and valves. This pump is reliable and rugged to withstand at continuous normal high pressure pumping operation. It supplies the feed water to a steam generator for the production of steam. This is used for energy conversion or other industrial use. This is used to hydrostatically test the boiler and other hydraulic applications.

Bolt/Stud Tensioners are independent of friction, precluding damage and reuse of studs, nuts & bolts. Its feature includes seal system reliability, controlled & accurate pre-loads for reliability and ease of bolt/ nut installation & removal and internal & external thread designs.

Booster pumps are used in applications where the normal system pressure is low and needs to be increased. Priming introduces fluid into the pumping chamber to create the pressure differential needed for pumping at a rated service. Booster pumps include a pump stator/rotor assembly that is mounted either vertically or horizontally, depending on the orientation of the media. These pumps are made of aluminum, brass, bronze, cast iron, plastic, or stainless steel. They are used in water systems or applications that have low contamination. The pumps also have a variety of commercial, municipal, and military applications and are used in a range of industries that includes aerospace, mining, and food processing. Booster pumps can transport different types of media. Some booster pumps use abrasive, acidic, corrosive, combustible, or hazardous materials. It provides a variety of features like thermal overload protection. Booster pumps are designed to function in special environments.