Drop amplifier is a lightweight powder coated and weather-sealed housing for superior corrosion protection. It provides ultra-low noise amplification of broadband signals for subscriber drop installations. It is available in one and four output, with GaAsFET technologies, and is configured for reverse path passive transmission. It allows very versatile deployment. To install, simply locate and mount the amplifier, and then connect the RF input cable and the RF output cables. It can either be powered directly in a co-located situation through an externally mounted transformer or it may be powered remotely by an externally mounted transformer via the cable through a power inserter. Its features are that it allows two-way transmission through passive reverse, low power consumption, low noise and excellent distortion performance and is suited for indoor and outdoor applications

Drop Ball Testers are used to test tempered lenses. This unit meets all applicable FDA and ANSI standards. These testers are designed for use with either ophthalmic lenses or safety industrial lenses. It is also available with two interchangeable tubes.

Drop Bottom Ovens are used for aluminum solution heat-treating. These ovens incorporate state of the art insulation, control system and hoist mechanism. They can be used for aluminum aging at lower temperatures. They have ceramic fiber block module insulation and electro-mechanical winch system. It also has stainless steel air baffle and provides electric or gas heating. This is electrically heated and designed for installation above the floor level. The quench tank is mounted on a transfer car that runs on rails. Load positioning and unloading is accomplished using a worktable mounted on the same transfer car. Loads are raised and lowered by a hoist system. The temperature range is 1200°F.