Beam Tracks are used to make the upper and lower parts of reverse and compound vertical curve. It provides strength and wear qualities than track made from mild steel. It is used to measure track widths, and determining scattering angles.

Beam Type Load Cells are used to construct the setup and cutting force measurement readings, which is recorded on a computer during the tests. Beam-type load cells are used to detect the load positioned on the detection bed.

Beam welder consists of the beam generator, which generates and deflects the beam, the vacuum chamber, and the vacuum-generating pumps, which evacuate the beam generator and the vacuum chamber. The beam generator can be flanged to the vacuum chamber in vertical or also in horizontal direction. The vacuum chamber is equipped with a two-axis mobile table for the workpiece receiver.

Beamsplitter Coatings provides glass, plastic and fiber optic components. These are designed for specific transmission and reflection ratio, wavelength region, polarization, incident angle and incident medium. Many designs are deposited at low temperature with excellent environmental properties. It is used for low power applications. It ensures uniform spectral performance even when the coating is applied to very large substrates. It split the incident energy, transmitting a portion and reflecting another portion. It offers energy beamsplitting products and dichroic (spectrum) beamsplitting products. It has two types of coating such as Metallic beamsplitting coatings and Dielectric beamsplitting coatings. Metallic beamsplitting coatings offer good performance over a moderate spectral region. Dielectric beamsplitting coatings can be designed for either narrow or broad wavelength ranges. It offers the advantages of minimal absorption and much higher resistance to abrasion.

Beamsplitters is an optical device that splits a beam of light in two. The intensity distribution among the beams will depend on whether a reference-beam or a dual-beam system is required. It is partially reflecting and transmitting mirrors. They can be made with an extremely thin film of metal or with a stack of thin films. The reflectance and transmittance of thin metal films is almost flat over the visible wavelength range. Polarizing beamsplitters reflect a large percentage of the S polarised beam while transmitting the P polarized beam. It is widely used in stereo photography to shoot stereo photos using a single shot with a non-stereo camera. The device attaches in place of the lens of the camera.